最新澳门网址大全

  • 地址:济南市槐荫区鑫苑世家公馆2号楼2603室
  • 电话:0531-87568508 /
  • 手机:18653128690
  • 邮箱:jnyhrs@163.com
  • 无尘车间洁净室装配式洁净室的安装窍门
    来源:最新澳门网址大全 浏览: 发布日期:2018-09-05
    1.装配式洁净室的安装,应在装饰工程完成后的室内进行。室内空间必须清洁、无积尘,并在施工安装过程中对零部件和场地随时清扫、擦净。
    1. the installation of assembly type clean rooms should be carried out indoors after the decoration works are completed. Indoor space must be clean, dust-free, and in the construction and installation process of parts and sites at any time to clean, clean.
    2.施工安装时,应首先进行吊挂、锚固件等与主体结构和楼面、地面的联结件的固定。
    2. In construction and installation, hanging and anchoring parts should be fixed first with the main structure, floor and ground.
    3.地面面层必须平整,其不平整度不应大于0.1%。在做卷材面层或涂料面层时应考虑与垂直壁板交接处的密封。
    3. the ground surface must be leveled, and its roughness should not be greater than 0.1%. When making coil surface or coating surface, the sealing should be considered at the junction with vertical wall panels.
    4.壁板安装前必须严格放线,墙角应垂直交接,防止累积误差造成壁板倾斜扭曲,壁板的垂直度偏差不应大于0.2%。
    4. Strictly lay out the line before the installation of the panels, the corner should be vertically handed over to prevent the cumulative error caused by the tilt and distortion of the panels, the deviation of the verticality of the panels should not be greater than 0.2%.
    无菌室装修
    5.吊顶应按房间宽度方向起拱,使吊顶在受荷载后的使用过程中保持平整。吊顶周边应与墙体交接严密。
    5. the ceiling should be arched according to the width of the room, so that the ceiling will be kept smooth during the use of the load. The surrounding of the ceiling should be closely connected with the wall.
    6.安装过程中不得撕下壁板表面塑料保护膜,禁止撞击和踩踏板面。
    6. during installation, the plastic protective film on the surface of the panel must not be ripped off.
    7.各种构配件和材料应存放在有围护结构的清洁、干燥的环境中,平整地放置在防潮膜上。
    7. All kinds of components and materials should be stored in a clean, dry environment with envelopes, placing smoothly on the moisture-proof film.
    8.构配件和材料的开箱启封应在清洁环境中进行,应严格检查其规格性能和完好程度,不合格或已损坏的构配件严禁安装。
    8. Opening and sealing of components and materials should be carried out in a clean environment. The specifications, performance and integrity should be strictly checked. Installation of unqualified or damaged components is strictly prohibited.
    9.需要粘贴面层的材料、嵌填密封胶的表面和沟槽必须严格清扫清洗,除去杂质和油污,确保粘贴密实,防止脱落和积灰。
    9. The materials that need to be bonded to the surface, the surfaces and grooves that need to be filled with sealant must be cleaned strictly to remove impurities and oil stains, to ensure the compactness of the paste, and to prevent shedding and ash deposition.
    10.装配式洁净室的安装缝隙,必须用密封胶密封。
    10. the installation gap of the assembly type clean room must be sealed with sealant.
    本文由无菌室装修整理发布,您是不是对这些内容有所了解了呢?更多的内容请点击:我们会有更多精彩内容等你查看。
    This article is published by the aseptic room decoration, do you know something about these contents? For more information, please click: , we will have more wonderful content for you to see.
    XML 地图 | Sitemap 地图